board_rbbrfa1.h File Reference

---

Detailed Description

Definition of Radio Controller Breakout Board (light and normal) from Dresden Elektronik, ATmega128RFA1 version.

The Breakout board is a carrier board for the radio controller board family.

Peripherals:
    KEY: PE5
    LEDS PE2:PE4

Fuses/Locks:
     LF: 0xe2 - 8MHz internal RC Osc.
     HF: 0x11 - without boot loader
     HF: 0x10 - with boot loader
     EF: 0xff
     LOCK: 0xef - protection of boot section

Bootloader:
    Start at byte=0x1e000, address=0xf000, size = 4096 instructions/ 8192 bytes

Build Options

• rbb128rfa1 : BB + RCB128RFA1

Definition in file board_rbbrfa1.h.

Go to the source code of this file.

Defines
#define	DDR_KEY   DDRE
#define	HIF_TYPE   HIF_UART_1
#define	HWTIMER_REG   (TCNT1)
#define	HWTIMER_TICK   ((1.0*HWTMR_PRESCALE)/F_CPU)
#define	HWTIMER_TICK_NB   (0xFFFFUL)
#define	HWTMR_PRESCALE   (1)
#define	INVERSE_KEYS   (1)
#define	LED_DDR   DDRE
#define	LED_MASK   (0x1c)
#define	LED_NUMBER   (3)
#define	LED_PORT   PORTE
#define	LED_SHIFT   (2)
#define	LEDS_INVERSE   (1)
#define	MASK_KEY   (0x20)
#define	MAX_FRAME_SIZE   (127)
#define	PIN_KEY   PINE
#define	PORT_KEY   PORTE
#define	PULLUP_KEYS   (1)
#define	SHIFT_KEY   (5)
#define	SLEEP_ON_KEY()
#define	SLEEP_ON_KEY_INIT()   do{}while(0)
#define	SLEEP_ON_KEY_vect   INT5_vect
#define	TIMER_INIT()
#define	TIMER_IRQ_vect   TIMER1_OVF_vect
#define	TIMER_POOL_SIZE   (4)
#define	TIMER_TICK   (HWTIMER_TICK_NB * HWTIMER_TICK)
#define	TRX_RESET_HIGH()   do { TRXPR |= _BV(TRXRST); } while (0)
#define	TRX_RESET_LOW()   do { TRXPR &= ~_BV(TRXRST); } while (0)
#define	TRX_SLPTR_HIGH()   do { TRXPR |= _BV(SLPTR); } while (0)
#define	TRX_SLPTR_LOW()   do { TRXPR &= ~_BV(SLPTR); } while (0)
#define	TRX_TSTAMP_REG   TCNT1

---

Define Documentation

#define MAX_FRAME_SIZE   (127)

maximum allowed frame size

Definition at line 75 of file board_rbbrfa1.h.

 

#define SLEEP_ON_KEY

(

)

Value:

do{\
            EIMSK |= _BV(INT5);\
            set_sleep_mode(SLEEP_MODE_PWR_DOWN);\
            sleep_mode();\
            EIMSK &= ~_BV(INT5);\
        } while(0)

Definition at line 99 of file board_rbbrfa1.h.

 

#define TIMER_INIT

(

)

Value:

do{ \
        TCCR1B |= (_BV(CS10)); \
        TIMSK1 |= _BV(TOIE1); \
    }while(0)

Definition at line 125 of file board_rbbrfa1.h.

#define TRX_TSTAMP_REG   TCNT1

timestamp register for RX_START event

Definition at line 79 of file board_rbbrfa1.h.